Camshaft, Measuring Axial Clearance

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Dial Gauge Holder VW387
Dial Gauge - 0-3mm VAS6080

Procedure

Fig 1: Securing Dial Gauge Holder VW 387 To Dial Gauge VAS 6080 On Cylinder Head

Courtesy of AUDI OF AMERICA, LLC

-- Remove the camshafts, refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Mark the assignment of the roller rocker lever for installation later.

-- Remove the roller rocker lever and place it on a clean surface.

-- Reinstall the camshafts and the guide frame, refer to Figure and tighten the old bolts to 8 Nm.

-- Secure the Dial Gauge Holder VW387with the Dial Gauge - 0-10mm VAS6079 on the cylinder head ash shown in the illustration.

-- Press the camshaft against the dial gauge by hand.

-- Set dial gauge to "0".

-- Press the camshaft off the dial gauge and read the value:

Axial play: 0.100 to 0.191 mm.