Clamping Sleeves, Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tensioning Inner Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Secure the spring clamp -3- on the boot -2- using the :V.A.G 1921 .

Fig 2: Identifying Power Steering Gear Boot

Courtesy of AUDI OF AMERICA, LLC

Boot, Assembling

Fig 3: Identifying Outer Boot Assembly Dimension -A-

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 2 mm

Further installation is in the reverse sequence to removal.

Tightening specifications, refer to ELECTROMECHANICAL POWER STEERING GEAR OVERVIEW .

Tightening specifications, refer to ELECTROMECHANICAL POWER STEERING GEAR WITH TIE RODS OVERVIEW .

-- An axle alignment may be required. Refer to WHEEL ALIGNMENT .

NOTE:

The wheel alignment must be performed on a VW/Audi approved alignment stand.