Right Seal On Transmission Between Bevel Box And Transmission, Replacing, Vehicles With All Wheel Drive
Special tools and workshop equipment required
- Puller - Crankshaft/Power Steering Seal: T20143
- Used Oil Collection and Extraction Unit: SMN372500
- Seal Installer - Bevel Box: T10243
- Grease. Refer to the Parts Information.
Procedure
Observe general notes. Refer to GENERAL INFORMATION .
Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
General repair instructions. Refer to GENERAL REPAIR INFORMATION .
-- Remove the bevel gear. Refer to BEVEL BOX, REMOVING .
-- Place the : SMN372500 under the transmission.
-- Pry out the sealing ring on transmission using the : T20143/1 or : T20143/2 .
-- Coat outer circumference and sealing lips of new seal with transmission fluid.
-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the Parts Information.
-- Install the seal all the way in using the : T10243 . Be careful not to tilt it.
-- Install the bevel box. Refer to BEVEL BOX, INSTALLING .
-- Check transmission fluid level. Refer to TRANSMISSION FLUID LEVEL, CHECKING .