Ribbed Belt Drive And Accessory Bracket Assembly Overview
WARNING: This page is about a different variant/trim than selected.
- Vibration Damper
- With ribbed belt pulley
- Removing and installing, refer to VIBRATION DAMPER
- Only possible to install in one position
- Bolt
- Replace
- 10 Nm plus an additional 90° turn
- Bolt
- 23 Nm
- Ribbed Belt Tensioning Damper
- Secure with locking pin T10060 A
- Removing and installing, refer to RIBBED BELT TENSIONER
- Bracket for Assemblies
- Removing and installing, refer to ACCESSORY ASSEMBLY BRACKET
- Bolt
- Tightening specifications, refer to [For transmission(s) 02E] Specifications
- Slide Bushing
- Generator
- Removing and installing. Refer to [For transmission(s) 02E] Removal and Installation
- Bolt
- Insert with locking compound; Locking compound.
- Tightening specification and sequence, refer to Fig 2
- Bushing
- Quantity: 2
- Bolt
- Tightening specifications, refer to Specifications
- A/C Compressor
- Removing and installing, refer to Removal and Installation
- Ribbed Belt
- Check for wear
- Before removing, mark the direction of rotation using chalk or a felt-tip pen.
- Removing and installing, refer to RIBBED BELT
- Do not kink
- When installing, make sure it is seated correctly on the ribbed belt pulleys
| -- Tighten the bolts in the following sequence: -1 to 6- in 2 steps:-- Install bolts by hand as far as the stop.-- Tighten to 40 Nm. |