Overview - Supercharger
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Lifting Eye
- Bolt
- 27 Nm
- Supercharger
- With charge air coolers
- Supercharger, removing and installing. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Overview - charge air cooler. Refer to OVERVIEW - CHARGE AIR SYSTEM .
- Secured on the Engine and Gearbox Bracket VAS6095A for repair work. Refer to SUPERCHARGER, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Secured on the Engine and Gearbox Bracket VAS6095A for leak test. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAK TEST .
- Insulation Plate
- Bolt
- 5 Nm
- Rubber Grommet
- Quantity: 2
- Intermediate Flange
- Bolt
- Tightening specification: 10 Nm
- Throttle Valve Control Module -J338-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Connection
- Bolt
- Tightening specification and sequence. Refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bracket
- For change-over valves
- Bolt
- 9 Nm
- Bolt
- Tightening specification and sequence. Refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing. Refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bleeder Screw
- 1.5 to 3.0 Nm
- For the left charge air cooler
- Bolt
- Tightening specification. Refer to Fig 4.
- Intake Air Temperature Sensor -G42-
- Removing and installing. Refer to Fig 4.
- O-Rings
- Replace
- Nut
- 20 Nm
- O-Ring
- Replace
- Threaded Pin
- 17 Nm
- Bolt
- 10 Nm
- Replace
- Self-locking
- Always clean the threaded holes with a thread tap before assembling.
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing. Refer to CHARGE AIR PRESSURE SENSOR, REMOVING AND INSTALLING .
- Seals
- Replace
- O-Ring
- Quantity 2
- Replace
- Connection
- For the crankcase ventilation
- Installed position. Refer to Fig 6
- O-Ring
- Quantity 2
- Replace
-- Tighten the nuts -arrows- to 5 Nm.
-- Tighten the nut -1- to 5 Nm.
Fig 4: Identifying Connector -1- & Intake Air Temperature Sensor/Manifold Absolute Pressure Sensor Bolts