Supercharger, Securing On Engine And Transmission Holder

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The openings on the bottom of the supercharger housing should make it possible to see and reach the charge air cooler.

Special tools and workshop equipment required

Engine and Gearbox Bracket VAS6095A VAS6095A
Gearbox Support T40206 with T40206/1 and Gearbox Support Supplement T40206/2

Procedure

Fig 1: Identifying Securing Supercharger To VAS 6095

Courtesy of AUDI OF AMERICA, LLC

Supercharger removed. Refer to SUPERCHARGER, REMOVING AND INSTALLING .

-- Insert the Gearbox Support T40206 with T40206/1 in the Engine and Gearbox Bracket VAS6095A.

-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1- (See Fig 1 and Fig 2).

-- Attach the Gearbox Support Supplement T40206/2 directly to the supercharger housing at the front and on the right side using the bolt -2-.

Installation position of the Gearbox Support Supplement T40206/2:

Fig 2: Identifying Support T40206/2 Installed Position

Courtesy of AUDI OF AMERICA, LLC

The seals -arrow 1- on the support must face downward.
It is possible to see and reach the charge air cooler through the openings -arrow 2- inside the supercharger housing.