Supercharger, Securing To Engine/Transmission Holder For Leak Test
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The seals on the Gearbox Support Supplements T40206/2should seal off the openings in the supercharger housing during the leak test.
Special tools and workshop equipment required
- Engine and Gearbox Bracket VAS6095A VAS6095A
- Gearbox Support T40206 with T40206/1 and Gearbox Support Supplement T40206/2
Procedure
- Supercharger removed. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
-- Insert the Gearbox Support T40206 with T40206/1 in the Engine and Gearbox Bracket VAS6095A.
-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1-.
-- Attach the Gearbox Support Supplement T40206/2 directly to the supercharger housing at the front and on the right side using the bolt -2-.
Installation position of the Gearbox Support Supplement T40206/2:
- The seals on the support seal off the openings inside the supercharger housing.