Selector Lever Cable, Assembly Overview: Notes
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Selector Lever Cable
- Do not bend
- SELECTOR LEVER CABLE, REMOVING AND INSTALLING
- in case of damaged rubber boot, selector lever cable must be replaced
- Ball socket and ball head must be free of oil and grease
- check whether selector lever cable rubber boot is engaged in selector mechanism shift unit and is sealed properly
- SELECTOR LEVER CABLE, ADJUSTING
- Clip
- for the selector lever cable on the selector mechanism function unit
- Always replace
- Screw
- 13 Nm
- For adjusting the selector lever cable
- Selector Lever Cable Bolts
- The plastic retaining spring on adjustment slide must lock the pins so that they cannot fall out.
- Adjustment Slide
- Selector shaft lever
- Ball socket and ball head must be free of oil and grease
- SELECTOR SHAFT LEVER, REMOVING AND INSTALLING
- Bracket
- For selector lever cable
- Screw
- 10 Nm
- Attaching bracket to transmission
- Clip
- for selector lever cable to bracket
- Always replace
- Screw
- 10 Nm
- Attaching bracket to transmission