Reducing Agent Passive Tank, Removing And Installing: Installation

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to REDUCING AGENT PASSIVE TANK AND ATTACHMENTS OVERVIEW .

-- Install the left underbody trim in the center. Refer to UNDERBODY TRIM PANELS .

-- Make sure the lines are clipped to the passive tank.

After Filling, the Following Steps Must be Performed:

-- Adapting Adaptation Value after Draining Reducing Agent or Replacing Components, refer to ADAPTING ADAPTATION VALUE AFTER DRAINING REDUCING AGENT OR REPLACING COMPONENTS .