Adapting Adaptation Value After Draining Reducing Agent Or Replacing Components
WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
The adaptation value in the engine control module must be adapted with the vehicle tester when the reducing agent is drained or one of the components listed below is replaced.
- Active Tank
- Reducing agent pump
- Reducing Agent Injector
- Reducing agent line
- Engine Control Module
-- Perform the adaptation using the Vehicle Diagnostic Tester in "Guided Functions " under "01-Adapting reducing agent tank adaptation values".