Electrical And Electronic Component Locations

Fig 1: Connecting Up VAS 5051 Scan Tool (ST) Using Cable VAS 5051/1 And K Wiring Adapter VAS 6017

Courtesy of AUDI OF AMERICA, LLC

Location: Data Link Connector (DLC) is located beneath knee bolster on left of steering wheel.

Fig 2: Shift Lock Solenoid In Selector Mechanism

Courtesy of AUDI OF AMERICA, LLC

Location: Shift lock solenoid -1- is located in selector mechanism.

The solenoid is permanently installed in selector mechanism and cannot be replaced separately. Removal and installation is only possible in conjunction with selector mechanism. Refer to SELECTOR MECHANISM .

Fig 3: Direct Shift Gearbox Components

Courtesy of AUDI OF AMERICA, LLC

Location: direct shift gearbox (DSG) mechatronic -J743- is bolted on to transmission housing at front and covered by transmission oil pan.

The control module is permanently integrated on direct shift gearbox (DSG) mechatronic -J743-.

• Checked by On-Board Diagnostics (OBD)

Refer to MECHATRONIC

Fig 4: Transmission Sensors And Bolts

Courtesy of AUDI OF AMERICA, LLC

Location: The transmission input speed (RPM) sensor -G182- and clutch oil temperature sensor -G509- -A- are attached to the transmission housing under direct shift gearbox (DSG) mechatronic -J743-.

• Checked by On-Board Diagnostics (OBD).

Refer to TRANSMISSION INPUT SPEED SENSOR AND CLUTCH OIL TEMPERATURE SENSOR .

Fig 5: Selector Lever Park Position Lock Switch F319

Courtesy of AUDI OF AMERICA, LLC

Location: The selector lever -E313- with tiptronic switch -F189- as well as selector lever park position lock switch -F319- are permanently integrated into circuit board -B- of the selector mechanism. Components cannot be replaced separately.

• Checked by On-Board Diagnostics (OBD)

Removal and installation of selector lever -E313- with tiptronic switch -F189- as well as selector lever park position lock switch -F319- can only be performed together with selector mechanism. Refer to SELECTOR MECHANISM .

Fig 6: Mechanical Limp Home with Active Control Module

Courtesy of AUDI OF AMERICA, LLC

Location: Integrated into instrument cluster

If Transmission Range (TR) Display flashes or lights up, refer to transmission control module safety functions. Refer to Transmission Control Module, Safety Functions

Instrument cluster, removing and installing. Refer to [For engine(s) CBRA, BPY, CETA, CCTA, CEPB, CDMA] Removal and Installation .

Fig 7: Slector Lever Scale Illumination -L101-

Courtesy of AUDI OF AMERICA, LLC

Location: In selector lever boot trim -1-.

• Checked by On-Board Diagnostics (OBD).

Selector lever scale illumination -L101-, removing and installing. Refer to SELECTOR LEVER SCALE ILLUMINATION .

Fig 8: Brake Light Switch -F-

Courtesy of AUDI OF AMERICA, LLC

Location: Brake light switch -arrow- is located in foot pedal assembly.

• Checked by On-Board Diagnostics (OBD).

Brake light switch, removing and installing. Refer to Removal and Installation .

Fig 9: Component Location Of Throttle Position (TP) Sensor G79 With Accelerator Pedal Position Sensor 2 G185

Courtesy of AUDI OF AMERICA, LLC

A programmed value from throttle position (TP) sensor -G79- and accelerator pedal position sensor 2 -G185- (integrated in accelerator pedal module) are saved in engine control module as a kick-down signal.

• Checked by On-Board Diagnostics (OBD).
• Signal transmitted from engine control module (ECM) to transmission control module (TCM) via CAN bus.

Accelerator pedal module, removing and installing. Refer to [For engine(s) CBRA, BPY, CETA, CCTA, CEPB, CDMA] Removal and Installation .