Shift Fork Group, Input Shaft, 1ST, 2ND And Reverse Gear Output Shafts Overview

Fig 1: Identifying Shift Fork Group, Input Shaft, 1st, 2nd And Reverse Gear Output Shafts Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 24 Nm
- Steel bolts (M8; 45 mm long)
- Quantity: 2
- For attaching the shift fork group, refer to item 2 in Fig 1 to the bearing bracket; Refer to item 3 in Fig 1
- Insert with locking fluid AMV 185 101 A1
Shift Fork Group
- Disassembling and assembling, refer to GEARSHIFT RAILS AND SELECTOR FORKS
Bearing Bracket
- Supports input shaft and input shaft in transmission cover
- Remove any locking compound still in the threaded holes with a thread cutter.
  NOTE:
  Outer roller bearing races on input and output shafts cannot be replaced individually.
  
  Roller bear outer races must not have any radial clearance in bearing bracket.
Input Shaft
- Disassembling and assembling, refer to INPUT SHAFT OVERVIEW
Output Shaft
- With 3rd and 4th gears
- 1st, 2nd and reverse gears, removing and installing, refer to SHIFT FORK GROUP, INPUT SHAFT, 1ST, 2ND AND REVERSE GEAR OUTPUT SHAFTS .
- Disassembling and assembling, refer to OUTPUT SHAFT
Thrust Washer
- For selector gear of 2nd gear
Inner Race/Needle Bearing
- For selector gear of 2nd gear
- Removing and installing, refer to item 26 in Figure
Needle Bearing
- For 2nd gear
2nd Gear Wheel
2nd Gear Inner Race
- Refer to item 23 in Figure
Intermediate Ring for 2nd Gear
- Refer to item 22 in Figure
Synchronizer Ring for 2nd Gear
- Refer to item 21 in Figure
Locking Collar/Synchronizer Hub for 1st and 2nd Gears
- Refer to item 20 in Figure
Inner Race/Needle Bearing
- For the 1st gear selector gear
- Removing and installing, refer to item 19 in Figure
Needle Bearing
- For 1st gear
Synchronizer Ring for 1st Gear
- Refer to item 17 in Figure
Intermediate Ring for 1st Gear
- Refer to item 16 in Figure
1st Gear Inner Race
- Refer to item 15 in Figure
1st Gear Wheel
Thrust Washer
- For 1st gear and reverse gear selector gears
Inner Race/Needle Bearing
- For reverse gear
- Removing and installing, refer to item 12 in Figure
Needle Bearing
- For reverse gear
Reverse Gear Wheel
- With reverse gear locking collar
- Refer to item 9 in Figure
Synchronizer Ring for Reverse Gear
- Refer to item 8 in Figure
Reverse Gear Intermediate Ring
- Refer to item 7 in Figure
Reverse Gear Inner Race
- Refer to item 6 in Figure
Reverse Gear Synchronizer Hub
- Can be manually removed from the output shaft
Thrust Washer