Section 233 (Gears, Shafts - Manual Transmission Internal Components 0B2 AWD (Cabriolet))
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- 35 Gears, Shafts
- Description And Operation
- Input Shaft Assembly Overview
- Output Shaft Assembly Overview
- Notes
- Installed Position: Locking Collar -2- And Reverse Gear Wheel -1-
- Checking Synchronizer Ring For Wear
- Characteristics Of The 1ST Gear -A- And 2ND Gear -B- Inner Races
- Checking Inner Race Of 1ST Gear For Wear
- Checking Intermediate Ring Of 1ST And 2ND Gear For Wear
- Assembly Of Locking Collar/Synchronizer Hub For 1ST And 2ND Gear
- Shift Fork Group, Input Shaft, 1ST, 2ND And Reverse Gear Output Shafts Assembly Overview
- Spur Gear Tapered Roller Bearing Pre-Load, Determining
- Adjusting Shim S6 For Positioning Center Differential, Determining
- Specifications
- Disassembly And Assembly
- Input Shaft
- Shift Fork Group, Input Shaft, 1ST, 2ND And Reverse Gear Output Shafts
- Output Shaft
- Notes
- Removing The 4TH Gear Wheel
- Removing The 3RD Gear Wheel
- Removing The Roller Bearing From The Output Shaft
- Installing The Roller Bearing On The Output Shaft
- Pressing On Gear-Wheel For 3RD Gear
- Pressing On Gear-Wheel For 4TH Gear
- Determine The 4TH Gear Wheel Locking Ring.
- Flange Shaft Mounting Needle Bearing, Removing From Output Shaft
- Flange Shaft Mounting Needle Bearing, Driving In Flush In The Output Shaft
- Spur Gear And Center Differential Bearing, Servicing
- Notes
- Removing The Inner Race / Tapered Roller Bearing From The Spur Gear
- Installing The Inner Race / Tapered Roller Bearing (Transmission Cover Side) On The Spur Gear
- Installing The Inner Race / Tapered Roller Bearing (Gear Carrier Side) On The Spur Gear
- Removing The Outer Race / Tapered Roller Bearing From The Gear Carrier
- Installing The Outer Race / Tapered Roller Bearing -A- In The Gear Carrier
- Removing The Small Ball Bearing -C- From The Center Differential
- Installing The Small Ball Bearing -A- In The Center Differential
- Removing The Large Ball Bearing -B- From The Center Differential
- Special Tools
- Description And Operation