Hydraulic Control Module, 0BE, 0BF: Installing: Notes

Fig 1: Identifying Hydraulic Control Unit

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Follow all Safety Precautions exactly when replacing the hydraulic control unit. Install the "old" sensors again if possible. Refer to SAFETY PRECAUTIONS AND TEST PROCEDURES

Conditions:

Replace the seal between the hydraulic control unit -1- and the final drive housing.
The centering pins -item 18- in HYDRAULIC CONTROL UNIT, 0BE, 0BF must be installed inside the housing for the hydraulic control unit.
The left -6- and right -7- lines must be installed loosely when attaching the hydraulic control unit -1-.