All Wheel Drive Pump -V415-, 0BE, 0BF: Removing

-- Place the vehicle on a lift.

The ignition is off.

-- Place Drip Tray under rear final drive.

-- Disconnect the connector -1- from the All Wheel Drive Pump -V415- -2-.

Fig 1: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the 4 bolts that connect the All Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket T10058.

-- Carefully remove the All Wheel Drive Pump -V415- -2-. Pay close attention to the adapter -item 4- in HYDRAULIC CONTROL UNIT, 0BE, 0BF inside the hydraulic pump while doing this.

NOTE:

The adapter could fall out when removing the All Wheel Drive Pump -V415-.

Insert the adapter into the recesses in the hydraulic pump before installing the All Wheel Drive Pump -V415-.