LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Air Conditioning System (Service Information)) >> Air Conditioning Panel >> Installation [08/2013 - ] >> Installation [08/2013 - ]

Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION (for Multi-Media Module Receiver Type) 
    NOTE:

    When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. INSTALL RADIO RECEIVER ASSEMBLY (for Radio Receiver Type) 
  3. INSTALL NO. 2 RADIO BRACKET (for Radio Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 5
  4. INSTALL NO. 1 RADIO BRACKET (for Radio Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 6
  5. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY (for Multi-Media Module Receiver Type) 
  6. INSTALL HARD DISK DRIVE (for Multi-Media Module Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 2
  7. INSTALL NO. 2 RADIO BRACKET (for Multi-Media Module Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 4
  8. INSTALL NO. 1 RADIO BRACKET (for Multi-Media Module Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 5
  9. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 9
  10. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET (for Multi-Media Module Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 6
  11. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL  . Refer to INSTALLATION [08/2013 - ] - Step 38
  12. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY  . Refer to INSTALLATION [08/2013 - ] - Step 39
  13. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH  . Refer to INSTALLATION [08/2013 - ] - Step 40
  14. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION [08/2013 - ] - Step 41
  15. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL (for Multi-Media Module Receiver Type) 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .

  16. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for Multi-Media Module Receiver Type)  . Refer to INSTALLATION [08/2013 - ] - Step 3
  17. INSPECT HARD DISK DRIVE (for Multi-Media Module Receiver Type) 

    Refer to OPERATION CHECK [08/2013 - ]

  18. PERFORM FOR MULTI-MEDIA MODULE RECEIVER ASSEMBLY INITIALIZATION (w/ Parking Assist Monitor System) 

    HINT: 

    When replacing the multi-media module receiver assembly, perform parking assist monitor system initialization. Refer to CALIBRATION [08/2013 - ] .

  19. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)  . Refer to CUSTOMIZE PARAMETERS [08/2013 - ] - Step 1
scientia non olet · About LEMON Manuals