Overview - Seals
WARNING: This page is about a different variant/trim than selected.
The shaft seals -C-, -D-, and -E- can be replace with the transmission installed. Refer to SEALS .
- Shaft Seal
- For the input shaft
- Refer to INPUT SHAFT SEAL, REPLACING
- Shaft Seal
- For the left flange shaft
- Refer to LEFT SEAL, REPLACING
- Shaft Seal
- For the right flange shaft
- Refer to RIGHT SEAL, REPLACING .
- Replacing with the transmission installed.
- Shaft Seal
- For the rear flange shaft or transmission output shaft with splines
- Removing and installing. Refer to CENTER DIFFERENTIAL HOUSING, SERVICING .
- Shaft Seal
- For the selector shaft
- Refer to Fig 2
- Replacing with the transmission installed. Refer to SELECTOR SHAFT SEAL, REPLACING
- Right Flange Shaft
- Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING
- Replacing with the transmission installed. Refer to RIGHT SEAL, REPLACING
- Final Drive Cover
- Refer to FINAL DRIVE COVER, REPLACING
- O-Ring
- On the final drive cover
- Replacing. Refer to FINAL DRIVE COVER, REPLACING .
- Differential
- Refer to OVERVIEW - DIFFERENTIAL
- Refer to DIFFERENTIAL, REMOVING AND INSTALLING
- Transmission
- Removing and installing. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Transmission Output Shaft with Splines
- With vibration damper; allocate correct components.
- Replace the shaft seal when replacing the transmission output shaft with splines -D-
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Transmission Output Shaft with Splines
- Without vibration damper; allocate correct components.
- Replace the shaft seal when replacing the transmission output shaft with splines -D-
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Dust Ring
- Replace after removing
- Rear Flange Shaft
- With and without vibration damper, allocate correct components.
- Removing and installing. Refer to CENTER DIFFERENTIAL HOUSING, SERVICING REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Left Flange Shaft
- Clutch Module
- Removing and installing. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .
- Bolt