Wheel Covers, Removing And Installing: Notes

Special tools and workshop equipment required

NOTE:

The attached trim can only be replaced, removal without destruction is not possible.

Remove adhesive residue on body if necessary.

The adhesive surfaces must free of dust and grease. Clean with Cleaning Solution -D 009 401 04-.

Apply Bonding Agent -D 355 205 A2- to the surface using the Applicator -D 009 500 25- on the body-side and let it dry for 10 minutes.

When installing, the trim must be applied according to the contours. It is not possible to make corrections later.

Press the covers with the Roller 3356 after installation.

For Fender Wheel Cover, Refer to Fender Wheel Cover .

For Side Panel Wheel Cover, Refer to Side Panel Wheel Cover .