Fender Wheel Cover

-- Remove the expanding clip under the wheel housing liner, heat the adhesive surface with a hot air blower and remove the cover in stages.

-- Clean the adhesive surface with Cleaning Solution D 009 401 04 and remove adhesive residue with Adhesive Strip Remover VAS6349, if necessary.

-- Apply the Adhesive -D 355 205 A2- with Applicator -D 009 500 25- in the adhesion area and let it dry for 10 minutes.

-- Remove the protective film sideways so that they can be reached when the fender cover is dismantled.

-- Position it above the centering pin from front to back and in line with the contour when installing.

-- Remove the protective film on the removal tabs between the fender and the cover and tighten it by hand in stages.

-- Install the expanding clip in the cover.