Engine Mount And Engine Support, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to OVERVIEW - SUBFRAME .
-- Tighten the subframe. Refer to SUBFRAME, SECURING .
-- Attach the universal joint to the steering gear. Refer to POWER STEERING GEAR, REMOVING AND INSTALLING .
-- Install the air guide pipe. Refer to OVERVIEW - AIR GUIDE PIPES AND AIR GUIDE HOSES .
-- Electrical connections and wiring routing. Refer to appropriate SYSTEM WIRING DIAGRAM.
-- Install the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
-- Install the front wheel housing liners and noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
-- Install the air guide hoses and screw-type clamps. Refer to Fig 1.
-- Install the air filter. Refer to AIR FILTER HOUSING .