LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (3.0L - Exhaust System & Emission Controls - Engine Code: CNRB) >> 26 Exhaust System, Emission Controls >> Exhaust Manifold >> Right Exhaust Manifold, Removing And Installing >> Installing

Right Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications:

NOTE:

Replace the seals and self-locking nuts.

-- Tighten the exhaust manifold nuts. Refer to Figure.

-- Install the air guide pipe. Refer to OVERVIEW - AIR GUIDE PIPES AND AIR GUIDE HOSES .

-- Install the upper section of the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .