Cooler Overview

Fig 1: Identifying Cooler Overview

Courtesy of AUDI OF AMERICA, LLC

Cooler -J698-
- Unit with compressor.
- Removing and installing, refer to COOLER J698 .
Bolt
- 5 Nm
- Quantity: 2
Edge Protection
- Quantity: 2
Compressor
- Unit with cooler -J698-.
- Removing and installing, refer to COOLER J698 .
Spacer Sleeve
- Quantity: 4
- Clipped into the base plate.
Fan
- Removing and installing, refer to FAN .
Bolt
- 2 Nm
- Quantity: 4
Connectors
- To the cooler compressor control module.
Connector
- Removing and installing, refer to CONNECTOR MOUNT .
Bolt
- 2 Nm
- Quantity: 2
Circuit Board
- Removing and installing, refer to CIRCUIT BOARD .
Bolt
- 0.9 Nm
- Quantity: 4
Retaining Bolt
Cover
- For cooler -J698-.
- Removing and installing, refer to COOLER COVER .
Seal
- Replace if damaged.
Cooler Compressor Control Module
- Removing and installing, refer to COOLER COMPRESSOR CONTROL MODULE .
Switch
- For cooler compressor.
- Removing and installing, refer to COOLER COMPRESSOR SWITCH .
Cover
- Quantity: 2
Bolt
- 2.5 Nm
- Quantity: 2
Hinge pin
- For the cooler -J698- cover.
- Removing and installing, refer to COOLER COVER .
Light Emitting Diode (LED)
- For cooling display
- Removing and installing, refer to COOLING LED .
Wiring Harness
- Cannot be replaced separately.
Bolt
- 1.5 Nm
- Quantity: 2
Clips
- Quantity: 2
- For securing the multi-box mount.