Cooling Led

Procedure 

Fig 1: Pushing Retaining Spring -2- To Side -Arrow- To Remove LED -3-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the cooler. Refer to COOLER J698 .

-- Free up the switch wiring harness.

-- Disconnect the wires -1, 4 and 5- on the switch.

-- Carefully push the retaining spring -2- to the side -arrow- and remove the LED -3-.

-- Disconnect the wire and connect the new LED wire.

-- Install the LED until it clicks.

-- Install the cooler. Refer to COOLER J698 .