Check locking button on selector lever handle

Check locking button for ease of movement:

• It must be possible to press locking button without great force.
• After releasing, the locking button must come all the way back out by itself

If specified values are not obtained:

• Check whether selector lever handle is installed correctly → Selector lever handle, removing and installing 
• Check whether selector rod or selector lever is bent.

Function test:

• Ignition switched on

Locking button on selector lever handle must be pressed for the following shifts. If it is not pressed, the selector lever cannot be shifted into specified position.

• "P" to "R" and also press brake pedal
• "D" to "S"
• "N" to "R" ; in standstill, also press brake pedal after long wait
• "R" to "P"

If specified values are not obtained:

• Check whether selector lever handle is installed correctly → Selector lever handle, removing and installing 
• Carry out "Guided Fault Finding" with Vehicle Diagnosis, Testing and Information System VAS 5051 and check Shift Lock Solenoid N110.
• Adjust selector lever cable → Selector lever cable, checking and adjusting .