LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2001 >> allroad Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.7L V6 BITURBO - APB, Bel >> Engine - Crankshaft, Cylinder block >> Engine crankshaft/crankcase, disassembly and assembly >> Dual-mass flywheel/drive plate; installation dimensions, removing and installing >> A - Flywheel >> Removing

A - Flywheel: Removing

Vehicles with four-wheel drive

See 6 SPD. MANUAL TRANSMISSION 01E .

Fig 1: Screwing In Clamping Bolt 3242 With Crankshaft At TDC
G02724326Courtesy of AUDI OF AMERICA, INC.
NOTE: The needle bearing is located in the flywheel and must be pressed in if a new flywheel is installed. See NEEDLE BEARING IN DUAL-MASS FLYWHEEL, REMOVING AND INSTALLING .
scientia non olet · About LEMON Manuals