Adaptation for powertrain data-BUS
NOTE:
- The adaptation values of the table under ADAPTATION FOR COMFORT SYSTEM DATA-BUS are input.
- Observe notes when replacing instrument cluster. See REPLACEMENT OF INSTRUMENT CLUSTER, INPUT VALUES .
Indicated on display
Fig 1: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (1 Of 9)
- Press -1 - and -0- and confirm by pressing the -Q- button.
Indicated on display
Fig 2: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (2 Of 9)
- Press -Q- button to confirm input.
Indicated on display
Fig 3: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (3 Of 9)
- Press buttons 6- and -0-.
- Press -Q- button to confirm input.
Indicated on display
Fig 4: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (4 Of 9)
- Press --> button.
Indicated on display
Fig 5: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (5 Of 9)
- Using the table in ADAPTATION FOR COMFORT SYSTEM DATA-BUS , input desired value using scan tool keypad, filling initial positions with "0".
for example desired input value: 1033 for manual transmission
Keypad input: 01033
Indicated on display
Fig 6: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (6 Of 9)
- Press -Q- button to confirm input.
Indicated on display
Fig 7: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (7 Of 9)
- Press -Q- button to confirm input.
Indicated on display
Fig 8: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (8 Of 9)
- Press -Q- button to confirm input.
Indicated on display
Fig 9: VAG 1551 Scan Tool Display - Adaptation For Powertrain Data-BUS, Instrument Cluster With Maintenance Interval Extension (9 Of 9)
- Conclude adaptation of powertrain data-BUS by pressing the --> button.
Table:
EQUIPMENT ADAPTATION VALUE (ADAPTATION FOR POWERTRAIN DATA-BUS)
| Equipment | Adaptation value |
|---|---|
| Engine | 1 |
| Transmission | 2 |
| Brake | 4 |
| A/C | 8 |
| ADR | 32 |
| Instrument cluster | 1024 |
Installed control modules that participate in the information system data-BUS (MEASURING VALUE BLOCK 125 and MEASURING VALUE BLOCK 126 ) are added.
NOTE:
The instrument cluster, which supports CAN, is not indicated in the measuring value block, but must be added anyway.
Example: Manual transmission
- Engine + A/C + instrument cluster = 1 + 8 + 1024 = 1033
Example: Automatic transmission
- Engine + transmission + A/C + instrument cluster = 1 +2 + 8 + 1024 = 1035