Read Measuring Value Block (function 08): Notes

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Initiate output Diagnostic Test Mode of instrument cluster. See INSTRUMENT CLUSTER ON BOARD DIAGNOSTIC (OBD), INITIATING .

Display on VAS 5051:

Fig 1: VAS 5051 Tester Display - Read Measuring Value Block (Instrument Cluster) (1 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Select diagnostic function "08 - read measured value block" in selection -1-.

Display on VAS 5051:

Fig 2: VAS 5051 Tester Display - Read Measuring Value Block (Instrument Cluster) (2 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Enter display group Max. input value = 255

Enter desired display group number in button field -2-. See Display group overview .
Press -Q- button to confirm input.

Display on VAS 5051:

Fig 3: VAS 5051 Tester Display - Read Measuring Value Block (Instrument Cluster) (3 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Display group X
1. Display field 1
2. Display field 2
3. Display field 3
4. Display field 4

NOTE:

If no display follows, a display field is not assigned.
To switch to a different display group, proceed as follows:

CHANGING DISPLAY GROUP

Display group	VAS 5051 tester
Higher	Press up button.
Lower	Press down button.

Press "08 - Erase DTC Memory" to end function <-- button.