A - Changing adaptation value using sliding bar:

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Display on VAS 5051:

Fig 1: VAS 5051 Tester Display - Changing Adaptation Value Using Sliding Bar (Instrument Cluster) (1 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Move sliding bar -5- into desired direction or press on the surface beside the sliding bar, to move it in the desired direction.
Press "Save" button -4-.

NOTE: If the "Save" button is not indicated on display, only a direct input via the keypad is possible. See B - Change adaptation value via direct input: .

Display on VAS 5051:

Fig 2: VAS 5051 Tester Display - Changing Adaptation Value Using Sliding Bar (Instrument Cluster) (2 Of 3)

Courtesy of AUDI OF AMERICA, INC.

1 - Channel X save
2 - Text display of selected channel or No indication
4 - original value X new value X

Confirm new adaptation value by pressing the "take over" button -3-.

Display on VAS 5051:

Fig 3: VAS 5051 Tester Display - Changing Adaptation Value Using Sliding Bar (Instrument Cluster) (3 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Channel X Value X stored

End function "10 - Adaptation" by pressing <-- button.