HID Unit Replacement
- Turn the combination light switch OFF.
- Make sure the ignition switch is in LOCK (0) position, then do the battery terminal disconnection procedure (see
BATTERY TERMINAL DISCONNECTION AND RECONNECTION
).
- Remove the headlight assembly (see
HEADLIGHT REPLACEMENT ).
- Remove the three mounting screws and the HID unit (A).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Disconnect the 4P connector (B) from the HID unit.
- Inspect the gasket (C) for damage. If damaged, replace it.
- Install the HID unit in the reverse order of removal.
- Do the battery terminal reconnection procedure (see
BATTERY REMOVAL AND INSTALLATION
).
- After replacement, adjust the headlights (see
HEADLIGHT ADJUSTMENT ).