DTC B18CF: Right BSI Alert Indicator Output Error
- Clear the DTCs with the HDS (see HOW TO RETRIEVE DTCS ).
- Press the engine start/stop button to select the ON mode, then wait for 10 seconds.
- Check for DTCs with the HDS (see HOW TO RETRIEVE DTCS
).
Is DTC B18CF indicated?
YES -Go to step 4.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connections.
- Press the engine start/stop button to select the OFF mode.
- Remove the door mirror cover (see POWER MIRROR REPLACEMENT ).
- Measure the resistance between right BSI alert indicator 2P connector terminal No. 1 and body ground. There should be less than 1.0 Ω.Fig 1: Measuring Resistance Between Right BSI Alert Indicator 2P Connector Terminal No. 1 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the resistance as specified?
YES -Go to step 7.
NO -Repair an open in the wire between the right BSI alert indicator and ground (G405).
- Press the engine start/stop button to select the ON mode, and within 3 seconds measure the voltage between right BSI alert indicator 2P connector terminals No. 1 and No. 2.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Does the voltage remain between 12 V and 1 V for 3 seconds after pressing the engine start/stop button to select the ON mode, then go down to 0 V?
YES -Replace the right BSI alert indicator (see BSI ALERT INDICATOR REMOVAL/INSTALLATION ).
NO -Go to step 8.
- Press the engine start/stop button to select the OFF mode.
- Disconnect the BSI control unit 16P connector.
- Measure the resistance between right BSI alert indicator 2P connector terminal No. 2 and body ground. There should be an open circuit or at least 1 MΩ.Fig 3: Measuring Resistance Between Right BSI Alert Indicator 2P Connector Terminal No. 2 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the resistance as specified?
YES -Go to step 11.
NO -Repair a short to ground in the wire between the BSI control unit and the right BSI alert indicator.
- Measure the resistance between BSI control unit 16P connector terminal No. 14 and right BSI alert indicator 2P connector terminal No. 2. There should be less than 1.0 Ω.Fig 4: Measuring Resistance Between BSI Control Unit 16P Connector Terminal No. 14 And Right BSI Alert Indicator 2P Connector Terminal No. 2
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the resistance as specified?
YES -Go to step 12.
NO -Repair an open in the wire between the BSI control unit and the right BSI alert indicator.
- Make sure the BSI control unit 16P connector is disconnected.
- Press the engine start/stop button to select the ON mode.
- Measure the voltage between right BSI alert indicator 2P connector terminal No. 2 and body ground. There should be less than 0.2 V.Fig 5: Measuring Voltage Between Right BSI Alert Indicator 2P Connector Terminal No. 2 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the voltage as specified?
YES -Replace the BSI control unit (see BSI CONTROL UNIT REMOVAL/INSTALLATION ).
NO -Repair a short to power in the wire between the BSI control unit and the right BSI alert indicator. If the problem is still present, replace the right BSI alert indicator (see BSI ALERT INDICATOR REMOVAL/INSTALLATION ).