Display And Gauge System (4-CYL)
- Component Location Index
- Self-diagnostic Function
- Notes
- Entering the self-diagnostic function with the HDS
- Entering the self-diagnostic function (manual method)
- The Indicator Drive Circuit Check
- Switch Input Check
- The Beeper Drive Circuit Check
- The LCD/MID Segment Check
- The Gauge Drive Circuit Check
- The Communication Line Check
- Ending the self-diagnostic function
- Circuit Diagram
- DTC Index
- DTC Troubleshooting
- DTC B1175: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Open
- DTC B1176: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Short
- DTC U0029: F-CAN Circuit Malfunction (BUS OFF)
- DTC U0100: Gauge Control Module Lost Communication with ECM/PCM
- DTC U0122: Gauge Control Module Lost Communication with VSA Modulator-Control Unit (VSA message)
- DTC U0127: Gauge Control Module Lost Communication with TPMS Control Unit (TPMS message)
- DTC U0131: Gauge Control Module Lost Communication with EPS Control Unit (EPS message)
- DTC U0151: Gauge Control Module Lost Communication with SRS Unit (SRS message)
- DTC U1282: Gauge Control Module Lost Communication with Driver's MICU
- DTC U1283: Gauge Control Module Lost Communication with Passenger's MICU
- Gauge Control Module Input Test
- Rewriting the ODO Data and Transferring the Maintenance Minder Data to a New Gauge Control Module
- Gauge Control Module Replacement
- Outside Air Temperature Indicator Calibration
- Select/Reset/Information Switch Test/Replacement