Entering the self-diagnostic function (manual method)
Before doing the self-diagnostic function, make sure the No 5 (7 5 A) fuse in the driver's under-dash fuse/relay box and the No 15 (10 A) fuse in the under-hood fuse/relay box are OK
- Push and hold the SEL/RESET switch.
- Turn the combination light switch ( ) ON
- Turn the ignition switch to ON (II)
- Within 5 sec, turn the combination light switch OFF, then ( ) ON and OFF again.
- Within 5 sec, release the SEL/RESET switch, and then push and release the button three times repeatedly
NOTE:
- While in the self-diagnostic mode, the dash lights brightness controller operates normally
- While in the self-diagnostic mode, the SEL/RESET switch is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check
- If the vehicle speed exceeds 1 2 mph (2 km/h) or the ignition switch is turned to LOCK (0), the self-diagnostic mode ends