LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> TSX Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Display And Gauge System (4-CYL) >> Select/Reset/Information Switch Test/Replacement

Select/Reset/Information Switch Test/Replacement

  1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT )
  2. Disconnect the 7P connector (A) from the select/reset/information switch (B)
    Fig 1: Identifying 7P Connector And Select/Reset/Information Switch
    G05995102Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the screws and the switch
  4. Measure the resistance between select/reset/information switch 7P connector terminals No 2 and No 6 in each switch position according to the table
    Fig 2: Identifying Select/Reset/Information Switch Terminals
    G05995103Courtesy of AMERICAN HONDA MOTOR CO., INC.
    SWITCH POSITION RESISTANCE CHART

    Position Resistance
      About 33 Ω
    SEL/RESET About 1,043 Ω
      About 363 Ω
  5. If the resistance is not as specified, replace the switch
  6. If the switch is OK, but there is a problem with the switch function, check the steering switches harness and cable reel
scientia non olet · About LEMON Manuals