Sunshade Replacement

Remove the drain channel (see DRAIN CHANNEL REPLACEMENT ).
Slide the sunshade (A) until you can see both sunshade slider spacers (B).

Fig 1: Sliding Sunshade
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then remove both spacers.
While lifting the front portion of the sunshade (A), move the sunshade forward until you can see both sunshade rear hooks (B). Do not damage the sunshade and hooks.

Fig 2: Identifying Front Portion Of Sunshade And Sunshade Rear Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then remove both hooks.
Remove the sunshade (A).

Fig 3: Removing Sunshade
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove both front sunshade base sliders (A) and both rear sunshade base sliders (B).

Fig 4: Removing Both Front Sunshade Base Sliders And Both Rear Sunshade Base Sliders
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the sunshade in the reverse order of removal, and check the glass position adjustment (see GLASS POSITION ADJUSTMENT ).
Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.