Glass Position Adjustment

The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/--1 mm (0+0.04/--0.04 in.) all the way around. If not, make the following adjustment:

Fig 1: Identifying Roof Panel And Glass Weatherstrip

Courtesy of AMERICAN HONDA MOTOR CO., INC.

1. Remove the bracket cover.
2. With a TORX T25 bit, loosen the bolts on each side, and adjust the glass (A).
   Fig 2: Bracket Cover Bolts W/Torque Specification

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. If necessary, repeat on the opposite side.