Drain Channel Replacement

Remove the glass (see GLASS REPLACEMENT ).
With the 5 mm hexagonal wrench, move both glass brackets (A) to the position where the moonroof normally tilts up and disconnect the drain channel rod (B) on both sides.

Fig 1: Disconnecting Drain Channel Rod On Both Sides
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Slide the drain channel (A) forward.

Fig 2: Sliding Drain Channel Forward
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull the rear edge of the drain channel (A) up while pushing both clips (B), and release the channel from both hooks (C) of the drain channel slider by pulling it rearward.

Fig 3: Pulling Rear Edge Of Drain Channel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the drain channel.
Install the channel in the reverse order of removal, and note these items:
- Push the clip portions into place securely.
- Check the glass position adjustment (see GLASS POSITION ADJUSTMENT ).
Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.