Display And Gauge System
- Component Location Index
- Circuit Diagram
- Self-diagnostic Function
- Gauge Control Module Replacement
- Rewriting the ODO Data on a New Gauge Control Module
- Outside Air Temperature Indicator Calibration
- Select/Reset/Information Switch Test/Replacement
- DTC Troubleshooting
- Notes
- DTC B1152: Gauge Control Module EEPROM Error
- DTC B1155: Gauge Control Module Lost Communication with Combination Switch Control Unit (Headlight Switch Message)
- DTC B1156: Gauge Control Module Lost Communication with Combination Switch Control Unit (Wiper Switch Message)
- DTC B1157: Gauge Control Module Lost Communication with Multiplex Integrated Control Unit (MICU)
- DTC B1158: Gauge Control Module Lost Communication with Relay Control Module
- DTC B1159: Gauge Control Module Lost Communication with Multiplex Integrated Control Unit (MICU) (Door Switch Message)
- DTC B1160: Gauge Control Module Lost Communication with Door Multiplex Control Unit (Door Lock Switch Message)
- DTC B1168: Gauge Control Module Lost Communication with ECM/PCM (Engine Messages)
- DTC B1169: Gauge Control Module Lost Communication with PCM (A/T Messages)
- DTC B1170: Gauge Control Module Lost Communication with VSA Modulator-Control Unit (VSA Message)
- DTC B1173: Gauge Control Module Lost Communication with TPMS Control Unit (TPMS Message)
- DTC B1175: Fuel Level Sensor (Fuel Gauge Sending Unit) Signals Input Error
- DTC B1177: Abnormal Battery Voltage (7.5 V)
- DTC B1178: F-CAN Communication Line Error