LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2004 >> TL Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Display And Gauge System >> DTC Troubleshooting >> DTC B1170: Gauge Control Module Lost Communication with VSA Modulator-Control Unit (VSA Message)

DTC B1170: Gauge Control Module Lost Communication with VSA Modulator-Control Unit (VSA Message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
  1. Clear the DTCs with the HDS.
  2. Turn the ignition switch OFF, and then back ON (II).
  3. Check for DTCs with the HDS.

    Is DTC B1170 indicated? 

    1. YES  - Go to step 4.
    2. NO  - Intermittent failure, the F-CAN communication line is OK at this time. Check for DTCs in the ECM/PCM and the VSA modulator-control unit with the HDS. If F-CAN DTCs are present, check for a loose VSA ground or poor connections at the VSA modulator-control unit or gauge control module. If the connections are good, check the battery condition (see BATTERY TEST ) and the charging system, then clear all DTCs.
  4. Check for DTCs in the ECM/PCM or VSA with the HDS.

    Are any DTCs indicated? 

    1. YES  - Go to the ECM/PCM or VSA indicated DTCs troubleshooting.
    2. NO  - Go to step 5.
  5. Do the GAUGE CONTROL MODULE INPUT TEST .

    Are all inputs OK? 

    1. YES  - Go to step 6.
    2. NO  - Repair the faulty input, then recheck the DTCs.
  6. Substitute a known-good gauge control module.
  7. Clear the DTCs with the HDS.
  8. Turn the ignition switch OFF, and then back ON (II).
  9. Check for DTCs with the HDS.

    Is DTC B1170 indicated? 

    1. YES  - Recheck ECM/PCM for DTCs, then recheck the VSA modulator-control unit for DTCs.
    2. NO  - The original gauge control module is faulty; replace it (see GAUGE CONTROL MODULE REPLACEMENT ).
scientia non olet · About LEMON Manuals