Installing the Boot

Fig 1: Removing Boot Preparations

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the boot is undamaged. Use a new boot if uncertain.

Tape the threads on the tie rod to protect the boot.

Install: 

• grease, P/N 1161001-1, on the steering rack and on the inside of the boot
• the boot. Secure the boot using new tie straps (2) (only applies to the right-hand tie rod)
• the lock nut (1) in its original position (count the number of turns).

The ball joint on the tie rod. See: Installing the ball joint for the tie rod.

If the boots are on the right-hand side.

Install: 

• the clamp (2) on the steering gear housing
• the heat deflector on the steering gear housing
• the mounting screw for the heat deflector
• the heat shield at the cowl panel.