Checking the 30-supply to the control module

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition OFF

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 2: Connecting Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Ignition off.
Connect the breakout box. Check the ground plate according to Connecting the breakout box .
Reconnect the control module.
Connect a voltmeter between terminals 19 (0 Volt) and 17 on the breakout box.

Fig 3: Breakout Box
Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 4: Identifying Voltage Display
Courtesy of VOLKSWAGEN UNITED STATES, INC.

The voltmeter should read approximately battery voltage.

OK
Refer to Checking the ground terminal for the pump motor
NOT OK
Refer to Checking for an open-circuit