Checking the wiring and component

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check the signal cable between control module terminal #72 and connector terminal #3 on boost pressure sensor 1. Check for an open-circuit according to Open-circuit, permanent faults . Check for a short-circuit to ground according to Short-circuit to ground, permanent faults .

Check the power supply cable between connector terminal #2 on boost pressure sensor 1 and control module terminal #74. Check for an open-circuit according to Open-circuit, permanent faults .

Remedy as necessary.

Try a new boost pressure sensor 1 if no fault is found during the above fault-tracing.

Other information

To connect the breakout box and access the control module, see Connecting the breakout box. EMS 2000
See Boost pressure sensor 1, replacing
See Signal specification

Fig 1: Identifying Boost Pressure Sensor Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying EMS2000

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Verification