Valve clearance, setting/adjusting: Finishing
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Remove the lifting beam and lifting hook.
Install:
- the power steering reservoir
- the metal bracket for the power steering hose on the rotation protection for the auxiliaries belt
- the auxiliaries belt
- the rear camshaft cover. See
- the trigger wheel. Tighten to 17 Nm
- the camshaft position (CMP) sensor housing. Tighten to 5 Nm
- the hose for the crankcase ventilation on the camshaft cover.
Check:
- the engine oil level
- the coolant level.
Warm up the engine until the thermostat opens.
Check the engine for leaks.
Top up the coolant if necessary.