Check the valve clearance

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking Valve Clearance

Courtesy of VOLVO CARS OF NORTH AMERICA.

Measure the valve clearance using a feeler gauge 9995752 at cylinder 1 intake valves and cylinder 3 exhaust valves.

Insert the feeler gauge through the inspection holes. Bend the feeler gauge with light finger pressure so that it follows the top of the valve lifter.

The correct measurement will not be obtained until the feeler gauge has gone in approximately 15 mm .

Reference Values

Valve:	Valve clearance:
Intake valve:	0.15-0.45 mm
Exhaust valve:	0.35-0.60 mm

NOTE: Carry out this check with the engine at room temperature.

Make a note of the valve clearance on a form.