Installing SIPS bags

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Install:

the tie straps
the clip for the connector
the steel clip
the tie straps
the two screws for the SIPS bag on the inside of the backrest frame.

Angle in and secure the protective pad on the side where the SIPS is located.

Install the backrest upholstery according to Backrest, replacing .

Tighten the SIPS bag screws. Tighten to 6 Nm .

Install the decals according to Steering wheel module and steering wheel .