Installing the control module

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: SRS Control Module With Torque Specifications

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Ensure that there is no dirt between the control module and the body bracket.

Connect the connector.

Lock the connector with the mounting bracket (2).

Install the sensor module using new screws. Tighten the screws. Tighten to 10 Nm .

NOTE: It is important that the sensor module is correctly installed on the chassis so that a collision can be registered.

Install the rear center console according to Rear center console .