Installing the ISOFIX

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: ISOFIX-Brackets

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Always use new screws and nuts when installing.

ISOFIX bracket (Right)

Position the ISOFIX against the backrest. Install new screws and washers (D).

Tighten the screws. Tighten to 18 Nm .

ISOFIX bracket (Left)

Position the ISOFIX against the backrest. Install new nuts (E), new screws and washers (F).

Tighten the nuts (E). Tighten to 22 Nm .

Tighten the screw (F). Tighten to 18 Nm .

Fig 2: Backrest Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the backrest using the screw (C). Tighten by hand
the new screw (A). Tighten by hand
the two new screws (B). Tighten by hand.

Tighten all the screws. Tighten to 22 Nm .

Install the fixed section of the rear seat.

Fold the seat cushion back into position.