Installing the combined instrument panel

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Column And DIM Casing Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the combined instrument panel.

Check that the connectors and the speedometer cable (if applicable) are correct for the combined instrument panel.

Press the combined instrument panel into place.

Install:

the surround around the combined instrument panel
the two screws (B) without sharp tips.

Lift up the steering shaft.

Install the two screws (A). Tighten to 21 Nm .