Transfer the Support To the New Drier
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Mark the position of the support on the old drier
- Slacken off the screws and remove the support. Transfer the markings to the new drier. Install the support.
- Slide in the rubber between the drier and the support
- Finger tighten the clamp of the support
- Transfer the pressure switch to the new receiver/drier
- Lubricate the O-rings with compressor oil
- Pressure switch tightening torques: 18 Nm.