Transfer the Support To the New Dryer
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Mark the support's position on the old dryer.
Loosen the clamp's bolt and remove the support. Transfer the marking from the old dryer to the new one and install the support.
Push in the rubber between dryer and the support's clamp.
Tighten the support's clamp finger-tight.
Transfer the pressure monitor to the new accumulator/dryer.
Lube the O-rings with compressor oil.
Pressure monitor, tightening torque: 18 Nm.