Installing the rear wheel sensor

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Clean off all dirt and rust from the sensor seat so that the sensor is correctly positioned in relation to the pulse wheel. Clean the pulse wheel using a soft brush
Grease the sensor lightly
Route the sensor cable through and install the sensor
Tighten to 55 Nm
Press the sensor lead into place in the support
Connect the connector
Install the protective cover.

Install the wheel hub, brake caliper and wheel according to Replacing rear wheel hubs